Home › Engine / Hybrid System › 2GR-FE EMISSION CONTROL › VACUUM SWITCHING VALVE
RM24M0E _51 Engine / Hybrid System _059544 2GR-FE EMISSION CONTROL _0291810 VACUUM SWITCHING VALVE G

2GR-FE EMISSION CONTROL  VACUUM SWITCHING VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VSV

A124791E01
1.22,0.601 2.001,0.780 0.781,0.179 10 23 to 26 Ω 1.176,2.462 2.309,2.663 1.133,0.201 10 10 MΩ or higher 1.839,1.173 1.943,1.347 0.104,0.173 10 1 1.312,2.106 1.416,2.269 0.104,0.163 10 2 1.555,1.62 1.839,1.276 false 1.524,1.709 1.394,2.083 false 0.229,2.209 1.043,3.011 0.814,0.802

a.

Measure the resistance of the purge VSV.

Standard resistance:
Tester Connection Specified Condition
1 - 2 23 to 26 Ω at 20°C (68°F)
1 - Body ground
2 - Body ground
10 MΩ or higher


If the result is not as specified, replace the purge VSV.


b.

Check the operation of the purge VSV.

i.
A124792E01
2.911,1.558 3.196,1.724 0.286,0.165 10 Air 1.743,1.338 1.930,1.499 0.187,0.161 10 E 1.102,1.275 1.271,1.470 0.169,0.195 10 F

Check that air does not flow from port E to port F.


ii.
A124793E01
1.967,1.498 2.178,1.659 0.211,0.161 10 Air 1.308,0.863 1.468,1.056 0.161,0.193 10 E 0.758,0.794 0.911,0.989 0.154,0.195 10 F

Apply battery voltage across the terminals.


iii.

Check that air flows from port E to port F.

If the result is not as specified, replace the purge VSV.