Home › Engine / Hybrid System › 2AZ-FE EMISSION CONTROL › AIR FUEL RATIO SENSOR › from 2016.05
RM24M0E _51 Engine / Hybrid System _059545 2AZ-FE EMISSION CONTROL _0291816 AIR FUEL RATIO SENSOR G

2AZ-FE EMISSION CONTROL  AIR FUEL RATIO SENSOR  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:

The type of ignition switch on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the "EXPRESSIONS OF IGNITION SWITCH" precaution (see page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>PRECAUTION).


PROCEDURE

Hide 89467B 1.CHECK AIR FUEL RATIO COMPENSATION SYSTEM

a.
B127990E07
0.531,2.615 0.885,2.865 0.885,2.865 0.885,2.896 false 1.781,2.125 2.125,2.167 false 0.375,2.865 1.5,3.031 1.125,0.167 10 false Intelligent Tester 2.156,2.083 2.615,2.25 0.458,0.167 10 false DLC3

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG).


c.

Select the following menu items: Data List / A/FS B1 S1 and O2S B1 S2.


d.

Warm up the A/F sensor with the engine speed at 2,500 rpm for approximately 2 minutes.


e.

Keep the engine speed at 2,500 rpm and confirm that the "A/FS B1 S1"display is as shown in the illustration.

HINT:
·

The illustration may slightly differ from the display on the intelligent tester.

·

Only the intelligent tester displays the waveform of the A/F sensor.




f.
A111996E04
0.762,0.476 2.074,0.688 1.312,0.211 10 Keep Engine Speed 0.145,1.484 0.401,1.699 0.257,0.215 10 (V) 0.024,1.783 0.382,1.935 0.357,0.152 10 3.3 V 2.714,1.001 3.085,1.149 0.371,0.149 10 Lean 2.706,1.791 3.056,1.963 0.350,0.172 10 14.6 2.716,2.548 3.091,2.731 0.375,0.183 10 Rich 2.998,1.954 3.347,2.478 0.349,0.524 10 Air Fuel Ratio 1.339,2.827 1.717,2.972 0.378,0.145 10 Time

Confirm that the "O2S B1 S2" display changes between 0 to 1 V with the engine speed at 2,500 rpm.

OK:

The voltage output oscillates more than 8 times in 10 seconds.


NOTICE:
·

Perform the check immediately after warming the engine up.

·

If the voltage variation could not be verified, warm up the A/F sensor again. If it could not be verified even after warming up the sensor again, check for DTCs (see page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).