Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › ENGINE ASSEMBLY
RM24M0E _51 Engine / Hybrid System _059547 2GR-FE ENGINE MECHANICAL _0291825 ENGINE ASSEMBLY G

2GR-FE ENGINE MECHANICAL  ENGINE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 17105 1.INSPECT EXHAUST MANIFOLD SUB-ASSEMBLY LH

a.
A134936

Using a precision straightedge and feeler gauge, measure the warpage on the contact surface of the cylinder head.

Maximum warpage:

0.7 mm (0.028 in.)


HINT:

The maximum allowable warpage of each installation surface is 0.3 mm (0.012 in.).


If the warpage is greater than the maximum, replace the manifold.


Hide 17104 2.INSPECT EXHAUST MANIFOLD SUB-ASSEMBLY RH

a.
A160274

Using a precision straightedge and feeler gauge, measure the warpage on the contact surface of the cylinder head.

Maximum warpage:

0.7 mm (0.028 in.)


HINT:

The maximum allowable warpage of each installation surface is 0.3 mm (0.012 in.).


If the warpage is greater than the maximum, replace the manifold.


Hide 17190 3.INSPECT INTAKE AIR SURGE TANK ASSEMBLY

a.
A134935

Using a precision straightedge and feeler gauge, measure the warpage on the contact surface of the intake manifold.

Maximum warpage:

2.5 mm (0.098 in.)

If the warpage is greater than the maximum, replace the surge tank.



Hide 17111 4.INSPECT INTAKE MANIFOLD

a.
A134934E01
0.153,0.02 1.573,0.252 1.420,0.232 10 Cylinder head side: 0.153,2.074 1.573,2.306 1.420,0.232 10 Surge tank side:

Cylinder head side:

i.

Using a precision straightedge and feeler gauge, measure the surface contacting the cylinder head for warpage.

Maximum warpage:

0.1 mm (0.003 in.)

If the warpage is greater than the maximum, replace the intake manifold.




b.

Surge tank side:

i.

Using a precision straightedge and feeler gauge, measure the surface contacting the surge tank for warpage.

Maximum warpage:

0.1 mm (0.003 in.)

If the warpage is greater than the maximum, replace the intake manifold.