Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › DRIVE BELT
RM24M0E _51 Engine / Hybrid System _059547 2GR-FE ENGINE MECHANICAL _0291826 DRIVE BELT G

2GR-FE ENGINE MECHANICAL  DRIVE BELT  INSPECTION  


PROCEDURE

Hide 16361A 1.INSPECT V-RIBBED BELT

a.
A131418E01
1.028,0.081 1.721,0.241 0.693,0.161 10 REPLACE 0.191,3.644 0.916,3.805 0.725,0.161 10 CORRECT 1.887,3.644 2.756,3.805 0.869,0.161 10 INCORRECT

Visually check the V-ribbed belt for excessive wear, frayed cords, etc.

If any defect has been found, replace the V-ribbed belt.

HINT:

Cracks on the rib side of a V-ribbed belt are considered acceptable.

If the drive belt has chunks missing from its ribs, it should be replaced.


HINT:
·

A "new belt" is a belt which has been used for less than 5 minutes with the engine running.

·

A "used belt" is a belt which has been used for 5 minutes or more with the engine running.




Hide 16620 2.INSPECT V-RIBBED BELT TENSIONER ASSEMBLY

a.

Check that nothing gets caught in the tensioner by turning it clockwise and counterclockwise.

If a malfunction exists, replace the tensioner.