Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › from 2016.05
RM24M0E _51 Engine / Hybrid System _059547 2GR-FE ENGINE MECHANICAL _0291828 FRONT CRANKSHAFT OIL SEAL A

2GR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11301C 1.INSTALL TIMING CHAIN CASE OIL SEAL

a.
A124982E12
2.344,1.646 2.344,2.063 2.344,2.063 2.063,1.542 false 1.344,0.229 2.167,0.406 0.823,0.177 10 false 0 to 1.0 mm 2.229,2.094 2.552,2.271 0.323,0.177 10 true SST

Apply MP grease to a new oil seal lip.


b.

Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

SST
09223-22010  
09506-35010  

Oil seal tap in depth:

0 to 1 mm (0 to 0.039 in.)


NOTICE:
·

Keep the lip free of foreign matter.

·

Do not tap the oil seal at an angle.




Hide 13471 2.INSTALL CRANKSHAFT PULLEY

HINT:
A366722E02
0.084,0 0.445,0.371 0.360,0.371 12 *A 1.843,0 2.204,0.371 0.360,0.371 12 *B

Type A and Type B can be distinguished by the number on the head of the crankshaft pulley set bolt.

Text in Illustration
*a Type A
*b Type B

Type Number on the Head
A 11
B 10


a.

Align the pulley set key with the key groove of the pulley, and slide on the pulley.


b.
A119084E01
2.172,2.985 2.545,3.169 0.373,0.184 10 SST 1.721,2.881 2.126,3.059 2.126,3.059 2.066,2.81 false

Using SST, install the pulley bolt.

SST
09213-70011  (09213-70020)
09330-00021  

Torque:
Type A : 260 N*m (2651 kgf*cm, 192 ft.*lbf)
Type B : 250 N*m (2549 kgf*cm, 184 ft.*lbf)


Hide 53736 5.INSTALL FRONT FENDER APRON SEAL RH

Hide 6.INSTALL FRONT WHEEL RH

T = 103 N*m{ 1,050 kgf*cm 76 ft.*lbf }