Home › Engine / Hybrid System › 2AZ-FE ENGINE MECHANICAL › DRIVE BELT
RM24M0E _51 Engine / Hybrid System _059548 2AZ-FE ENGINE MECHANICAL _0291831 DRIVE BELT G

2AZ-FE ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16361A 1.CHECK FAN & GENERATOR V BELT

a.
A058797E23
0.677,0.146 1.573,0.344 0.896,0.198 10 false INCORRECT

Visually check the drive belt for excessive wear, frayed cords, etc.

If any defect has been found, replace the drive belt.

HINT:

Cracks on the rib side of a drive belt are considered acceptable.

If the drive belt has chunks missing from the ribs, it should be replaced.



b.
A087787E39
0.219,1.156 1.01,1.385 0.792,0.229 10 false CORRECT 1.792,1.156 2.667,1.385 0.875,0.229 10 false INCORRECT

After installing the drive belt, check that it fits properly in the ribbed grooves.

Check with your hand to confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley.