1.REMOVE RADIO SETTING CONDENSER
Remove the bolt and condenser.
2.REMOVE OIL PRESSURE SWITCH
Using a 24 mm deep socket wrench, remove the sensor.
89422
3.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Using SST, remove the sensor and gasket.
11102A
4.REMOVE CAMSHAFT POSITION SENSOR
Remove the bolt and sensor.
11821
5.REMOVE NO. 2 CAMSHAFT BEARING
Remove the No. 2 camshaft bearing.
11811
6.REMOVE NO. 1 CAMSHAFT BEARING
Remove the No. 1 camshaft bearing.
13751
7.REMOVE VALVE LIFTER
Arrange the valve lifters in the correct order.
13711
8.REMOVE INTAKE VALVE
Place the cylinder head on wooden blocks.
Using SST, compress the spring, then remove the 2 retainer locks.
Remove the retainer, spring and valve from the cylinder head.
Arrange the removed parts in the correct order.
13715
9.REMOVE EXHAUST VALVE
Place the cylinder head on wooden blocks.
Using SST, compress the spring, then remove the 2 retainer locks.
Remove the retainer, spring and valve from the cylinder head.
Arrange the removed parts in the correct order.
13734
10.REMOVE VALVE SPRING SEAT
Using compressed air and a magnetic finger, remove the spring seat by blowing air.
Arrange the valves, valve springs, spring seats and spring retainers in the correct order.
13711A
11.REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the 16 oil seals.