1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
89465
2.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
17430
3.REMOVE TAILPIPE ASSEMBLY
Remove the 2 bolts and 2 compression springs.
Disconnect the 3 exhaust pipe supports and remove the tailpipe.
Remove the gasket from the center exhaust pipe.
17420
4.REMOVE CENTER EXHAUST PIPE ASSEMBLY
Remove the 2 bolts.
Disconnect the 2 exhaust pipe supports and remove the center exhaust pipe.
Remove the gasket from the front exhaust pipe.
17410
5.REMOVE FRONT EXHAUST PIPE ASSEMBLY
Remove the 2 bolts, 2 compression springs and front exhaust pipe.
Remove the gasket from the exhaust manifold.