85927
1.INSPECT NO. 1 FAN RELAY
Remove the relay from engine room relay block No. 2.
Measure the resistance of the relay.
| Tester Connection | Specified Condition |
|---|---|
| 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω
(when battery voltage is applied to terminals 1 and 2) |
If the result is not as specified, replace the cooling fan relay.
Install the relay to engine room relay block No. 2.
85927A
2.INSPECT NO. 2 FAN RELAY
Remove the relay from engine room relay block No. 2.
Measure the resistance of the relay.
| Tester Connection | Specified Condition |
|---|---|
| 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω
(when battery voltage is applied to terminals 1 and 2) |
If the result is not as specified, replace the cooling fan relay.
Install the relay to engine room relay block No. 2.