Home › Engine / Hybrid System › 2GR-FE COOLING › RADIATOR
RM24M0E _51 Engine / Hybrid System _059551 2GR-FE COOLING _0291847 RADIATOR A

2GR-FE COOLING  RADIATOR  DISASSEMBLY  


PROCEDURE

Hide 16400B 1.REMOVE RADIATOR DRAIN COCK PLUG

a.

Remove the drain plug.


b.

Remove the O-ring.


Hide 16441 2.REMOVE UPPER RADIATOR TANK

a.
A113337E02
2.732,0.189 3.159,0.352 0.427,0.163 10 Part A 1.998,1.636 2.828,1.826 0.830,0.191 10 Stopper Bolt 0.151,1.37 1.050,1.533 0.899,0.163 10 Dimension B 1.328,2.757 1.656,2.929 0.327,0.172 10 SST 1.929,2.867 3.036,3.030 1.107,0.163 10 Overhaul Handle 2.383,0.691 2.687,0.273 false 2.434,1.619 2.85,1.042 false 0.311,2.757 0.703,2.955 0.392,0.198 10 Claw 1.495,2.516 1.495,2.71 false 0.493,2.484 0.493,2.715 false

Install the claw to the overhaul handle, inserting it in the hole in part A as shown in the illustration.

SST
09230-01010  (09231-01010, 09231-01030)


b.

While squeezing the handle, adjust the stopper bolt so that dimension B is as specified below.

Dimension B:

0.2 to 0.3 mm (0.008 to 0.012 in.)


NOTICE:

If the stopper bolt is not adjusted, the claw may be damaged.



c.
A132661E01
0.188,1.196 0.877,1.369 0.690,0.174 10 Lock Plate 0.587,0.948 0.587,1.186 false 0.784,0.14 1.143,0.320 0.360,0.179 10 Tank 0.554,0.57 0.67,0.228 0.67,0.228 0.755,0.228 false 1.146,0.63 1.262,0.287 1.262,0.287 1.347,0.287 false 1.405,0.209 1.716,0.393 0.311,0.184 10 SST

Using SST, uncrimp the lock plate by squeezing the handle until stopped by the stopper bolt.

SST
09230-01010  


d.
A132662

Lightly tap the bracket of the radiator (or radiator hose inlet or outlet) with a soft-faced hammer and remove the tank.


e.

Remove the O-ring.


Hide 16461 3.REMOVE LOWER RADIATOR TANK

HINT:

The removal procedure for the lower radiator tank is the same as that for the upper radiator tank.