Home › Engine / Hybrid System › 2GR-FE COOLING › RADIATOR
RM24M0E _51 Engine / Hybrid System _059551 2GR-FE COOLING _0291847 RADIATOR G

2GR-FE COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16401 1.CHECK RADIATOR RESERVOIR CAP SUB-ASSEMBLY

a.
A112200

Measure the valve opening pressure.

i.

If there are water stains or foreign matter on O-ring 1, clean it with water and finger scouring.


ii.

Check that O-ring 1 is not deformed, cracked or swollen.


iii.

Apply engine coolant to O-ring 1 and rubber packing 2 before using a radiator cap tester.


iv.
A110393E28
0.271,1.198 0.5,0.167 0.5,0.167 0.573,0.167 false 1.583,1.063 1.688,0.521 1.688,0.521 1.771,0.521 false 1.813,0.417 3.104,0.604 1.292,0.188 10 false Radiator Cap Tester 0.635,0.063 1.615,0.25 0.979,0.188 10 false Reservoir Cap 0.333,2.125 1.177,2.333 0.844,0.208 10 false 30° or more

When using the cap tester, tilt it more than 30°.


v.

Pump the cap tester several times, and check the maximum pressure*.

Pump speed:

1 pump per second


*: Even if the cap cannot maintain the maximum pressure, it is not a defect.

Judgment criterion:
Item Specified Condition
Standard value
(for brand-new cap)
93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard value
(for used cap)
78.5 kPa (0.8 kgf/cm2, 11.4 psi)


If the maximum pressure is less than the minimum standard value, replace the radiator reservoir cap sub-assembly.