Home › Engine / Hybrid System › 2AZ-FE COOLING › COOLING FAN SYSTEM
RM24M0E _51 Engine / Hybrid System _059552 2AZ-FE COOLING _0291849 COOLING FAN SYSTEM G

2AZ-FE COOLING  COOLING FAN SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK COOLING FAN OPERATION AT LOW TEMPERATURES (Below 94°C (201°F))

a.

Turn the ignition switch ON (IG) with the A/C switch OFF.


b.
A132603

Check that the cooling fan stops.

If it does not, check the cooling fan relays and engine coolant temperature sensor, and then check for disconnection of the connector or a wire break between the cooling fan relay and engine coolant temperature sensor.


c.
A112176

Disconnect the engine coolant temperature sensor connector.


d.
A114390

Check that the cooling fan rotates.

If it does not, check the fuses, cooling fan relays, ECM and cooling fan, and then check for an open circuit between the cooling fan relay and engine coolant temperature sensor.


e.

Reconnect the engine coolant temperature sensor connector.


Hide 2.CHECK COOLING FAN OPERATION AT HIGH TEMPERATURES (Above 96°C (205°F))

a.

Start the engine, and then raise the coolant temperature to above 96°C (205°F).

HINT:

Coolant temperature is the value detected by the engine coolant temperature sensor on the cylinder head.



b.

Check that the A/C switch is OFF.


c.
A114390

Check that the cooling fan rotates.

If it does not, check the engine coolant temperature sensor, cooling fan, harness or connector.