Home › Engine / Hybrid System › 2AZ-FE COOLING › RADIATOR
RM24M0E _51 Engine / Hybrid System _059552 2AZ-FE COOLING _0291853 RADIATOR A

2AZ-FE COOLING  RADIATOR  DISASSEMBLY  


PROCEDURE

Hide 16400B 1.REMOVE RADIATOR DRAIN COCK PLUG

a.

Remove the drain plug.


b.

Remove the O-ring.


Hide 2.ASSEMBLE SST

a.
A113337E02
2.732,0.189 3.159,0.352 0.427,0.163 10 Part A 1.998,1.636 2.828,1.826 0.830,0.191 10 Stopper Bolt 0.151,1.37 1.050,1.533 0.899,0.163 10 Dimension B 1.328,2.757 1.656,2.929 0.327,0.172 10 SST 1.929,2.867 3.036,3.030 1.107,0.163 10 Overhaul Handle 2.383,0.691 2.687,0.273 false 2.434,1.619 2.85,1.042 false 0.311,2.757 0.703,2.955 0.392,0.198 10 Claw 1.495,2.516 1.495,2.71 false 0.493,2.484 0.493,2.715 false

Install the claw to part A of the overhaul handle as shown in the illustration.

SST
09230-01010  


b.

While squeezing the handle, adjust the stopper bolt so that dimension B is as specified below.

Dimension B:

0.2 to 0.3 mm (0.008 to 0.012 in.)



Hide 3.UNCAULK LOCK PLATE

a.
A132661E01
0.188,1.196 0.877,1.369 0.690,0.174 10 Lock Plate 0.587,0.948 0.587,1.186 false 0.784,0.14 1.143,0.320 0.360,0.179 10 Tank 0.554,0.57 0.67,0.228 0.67,0.228 0.755,0.228 false 1.146,0.63 1.262,0.287 1.262,0.287 1.347,0.287 false 1.405,0.209 1.716,0.393 0.311,0.184 10 SST

Using SST to release the caulking, squeeze the handle until stopped by the stopper bolt.

SST
09230-01010  


Hide 16461 4.REMOVE RADIATOR TANK INLET AND TANK OUTLET

a.
A132662

Lightly tap the bracket of the radiator (or radiator hose inlet or outlet) with a plastic-faced hammer and remove the tank.


b.

Remove the O-ring.