16401
1.CHECK RADIATOR RESERVOIR CAP SUB-ASSEMBLY
Measure the valve opening pressure.
If there are water stains or foreign matter on O-ring 1, clean it with water and finger scouring.
Check that O-ring 1 is not deformed, cracked or swollen.
Apply engine coolant to O-ring 1 and rubber packing 2 before using a radiator cap tester.
When using the cap tester, tilt it more than 30°.
Pump the cap tester several times, and check the maximum pressure*.
1 pump per second
*: Even if the cap cannot maintain the maximum pressure, it is not a defect.
| Item | Specified Condition |
|---|---|
| Standard value
(for brand-new cap) |
93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi) |
| Minimum standard value
(after using cap) |
78.5 kPa (0.8 kgf/cm2, 11.4 psi) |
If the maximum pressure is less than the minimum standard value, replace the radiator reservoir cap sub-assembly.