Home › Engine / Hybrid System › 2GR-FE LUBRICATION › OIL PUMP
RM24M0E _51 Engine / Hybrid System _059553 2GR-FE LUBRICATION _0291858 OIL PUMP G

2GR-FE LUBRICATION  OIL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL PUMP RELIEF VALVE

a.
A094628

Coat the relief valve with engine oil and check that it falls smoothly into the valve hole under its own weight.

If the valve does not fall smoothly, replace the relief valve. If necessary, replace the oil pump assembly.


Hide 2.INSPECT OIL PUMP ROTOR SET

a.
A128010E12
1.542,0.219 1.115,0.219 1.115,0.219 1.469,1.125 false 1.542,0.198 1.542,0.24 false 1.469,1.115 1.469,1.146 false 0.719,0.135 1.094,0.333 0.375,0.198 10 true Mark

Install the rotors to the timing chain cover with the rotors' marks facing outward. Check that the rotors rotate smoothly.


b.
A128011

Check the tip clearance.

i.

Using a feeler gauge, measure the clearance between the drive and driven rotors, as shown in the illustration.

Tip clearance:
Standard Maximum
0.060 to 0.160 mm (0.0024 to 0.0063 in.) 0.160 mm (0.0063 in.)


If the clearance is greater than the maximum, replace the drive and driven rotors.



c.
A128012

Check the side clearance.

i.

Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge, as shown in the illustration.

Side clearance:
Standard Maximum
0.030 to 0.090 mm (0.0012 to 0.0035 in.) 0.090 mm (0.0035 in.)


If the side clearance is greater than the maximum, replace the timing chain cover.



d.
A128013

Check the body clearance.

i.

Using a feeler gauge, measure the clearance between the timing chain cover and driven rotor, as shown in the illustration.

Body clearance:
Standard Maximum
0.250 to 0.325 mm (0.0098 to 0.0128 in.) 0.325 mm (0.0128 in.)


If the body clearance is greater than the maximum, replace the timing chain cover.