Home › Engine / Hybrid System › 2AZ-FE LUBRICATION › LUBRICATION SYSTEM
RM24M0E _51 Engine / Hybrid System _059554 2AZ-FE LUBRICATION _0291859 LUBRICATION SYSTEM G

2AZ-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

a.

Warm up the engine, stop the engine and wait for 5 minutes.


b.

Check that the engine oil level is between the L and F marks of the oil dipstick.

If low, check for leaks and add oil up to the F mark.

NOTICE:

Do not add engine oil above the F mark.



Hide 2.CHECK ENGINE OIL QUALITY

a.

Check the oil for deterioration, water intrusion, discoloration or thinning.

If the quality is visibly poor, replace the oil.

Standard Oil Grade
Oil Grade Oil Viscosity (SAE)

API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil


·

5W-30

·

10W-30


API grade SL, SM or SN multigrade engine oil
·

15W-40

·

20W-50



Standard Oil Grade (Destination package for Australia, China, New Zealand, Singapore, Taiwan)
Oil Grade Oil Viscosity (SAE)

API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil


·

0W-20

·

5W-20

·

5W-30

·

10W-30


API grade SL, SM or SN multigrade engine oil
·

15W-40

·

20W-50




Hide 3.CHECK OIL PRESSURE

a.

Disconnect the oil pressure switch connector.


b.
A112272

Using a 24 mm deep socket wrench, remove the oil pressure switch.


c.
A112273E03
1.354,0.292 2.198,0.448 true 1.094,0.146 1.323,0.344 0.229,0.198 10 true *1

Install an oil pressure gauge.

Text in Illustration
*1 Oil Pressure Gauge


d.

Warm up the engine.


e.

Measure the oil pressure.

Standard oil pressure:
Condition Specified Condition
Idle 32 kPa (0.3 kgf/cm2, 4.4 psi) or more
3,000 rpm 170 to 300 kPa (1.7 to 3.1 kgf/cm2, 24 to 44 psi)



f.

Remove the oil pressure gauge.


g.
A379255E01
1.313,0.406 1.927,0.698 false 1.125,0.302 1.438,0.5 0.313,0.198 10 false *1

Apply adhesive to 2 or 3 threads of the oil pressure switch.

Text in Illustration
*1 Adhesive

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or Equivalent



h.

Using a 24 mm deep socket wrench, install the oil pressure switch.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour of installation.



i.

Connect the oil pressure switch connector.


j.

Check for engine oil leaks.