Home › Drivetrain › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM › from 2016.05
RM24M0E _52 Drivetrain _059557 TIRE AND WHEEL _0291871 TIRE PRESSURE WARNING SYSTEM U

TIRE AND WHEEL  TIRE PRESSURE WARNING SYSTEM  TERMINALS OF ECU  


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER


a.
U189608E01
0.337,1.088 0.633,1.259 0.296,0.170 10 M44 0.144,0.088 0.353,0.274 0.209,0.186 10 *a

Disconnect the M44 tire pressure warning ECU and receiver connector and measure the voltage and resistance on the wire harness side.

Text in Illustration
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
M44-1 (IG) - M44-12 (GND) L - W-B IG power source Engine switch on (IG) 10 to 16 V
M44-12 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω


b.

Connect the M44 tire pressure warning ECU and receiver connector.


c.

Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may be malfunctioning.

HINT:

Inspect the connectors from the back side while the connectors are connected.


U189872E01
0.115,0.09 0.442,0.337 0.327,0.247 10 *a 2.019,0.877 2.344,1.029 0.325,0.152 10 M44

Text in Illustration
*a Component with harness connected
(Tire Pressure Warning ECU and Receiver)
- -

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
M44-2 (SPD) - M44-12 (GND) P - W-B Vehicle speed signal Vehicle is running Pulse generation (see waveform 1)
M44-3 (TC) - M44-12 (GND) L - W-B TC terminal Terminal TC is not connected 11 to 14 V
M44-5 (IND) - M44-12 (GND) B - W-B Tire pressure warning light output signal
·

Engine switch on (IG)

·

Tire pressure warning light off


3.2 V or higher
·

Engine switch on (IG)

·

Tire pressure warning light on


0.9 to 3.2 V
M44-7 (CLSW) - M44-12 (GND) W-B - W-B Tire pressure warning reset switch signal
·

Engine switch on (IG)

·

Tire pressure warning reset switch on


Below 1.5 V
·

Engine switch on (IG)

·

Tire pressure warning reset switch off


8 to 15 V
M44-10 (SIL) - M44-12 (GND) LG - W-B Diagnostic tester communication line Engine switch on (IG) 11 to 14 V


d.
U110360E04
0.635,1.135 1.031,1.333 0.396,0.198 10 false *a

Using an oscilloscope, check waveform 1.

Text in Illustration
*a GND

Waveform 1:
Item Contents
Terminal M44-2 (SPD) - M44-12 (GND)
Tool setting 5 V/DIV., 20 ms./DIV.
Vehicle condition Driving at 20 km/h (12 mph)

HINT:

The wavelength becomes shorter as the vehicle speed increases.