Tire pressure warning system DTCs can be checked by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by blinking the tire pressure warning light.
Disconnect the M44 tire pressure warning ECU and receiver connector.
Disconnect the A7 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M44-3 (TC) - G15-13 (TC) | Always | Below 1 Ω |
| M44-3 (TC), A7-27 (TC) or G15-13 (TC) - Body ground | Always | 10 kΩ or higher |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G15-4 (CG) - Body ground | Always | Below 1 Ω |
| *a | Front view of DLC3 |
OK
NG