Home › Brake › BRAKE › BRAKE MASTER CYLINDER(for LHD)
RM24M0E _54 Brake _059558 BRAKE _0291875 BRAKE MASTER CYLINDER(for LHD) G

BRAKE  BRAKE MASTER CYLINDER(for LHD)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK BRAKE FLUID LEVEL WARNING SWITCH

a.

Remove the reservoir filler cap and strainer.


b.

Disconnect the brake fluid level warning switch connector.


c.
C133367

Measure the resistance of the switch.

HINT:

There is a float inside the reservoir. Its position can be changed by increasing or decreasing the brake fluid level.


Standard resistance:
Tester Connection Condition Specified Condition
1 - 2 Float up (Switch OFF) 10 kΩ or higher
1 - 2 Float down (Switch ON) Below 1 Ω


If the value is not as specified, replace the brake master cylinder reservoir sub-assembly.


d.

Add brake fluid to the MAX level.