47201
1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure that the tip of the master cylinder points downward when handling the master cylinder.
Make sure foreign matter does not attach to the master cylinder's piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.
Install a new O-ring to the master cylinder.
Install the master cylinder to the booster with the 2 nuts (labeled A).
Using a union nut wrench, connect the 2 brake lines (labeled B) to the master cylinder.
| *a | Torque Wrench Fulcrum Length |
Do not kink or damage the brake lines.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
Calculate the torque wrench reading when changing the fulcrum length for the torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
w/o VSC:
When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 250 mm (9.84 in.)):
14 N*m (142 kgf*cm, 10 ft.*lbf)
w/ VSC:
When using a union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 250 mm (9.84 in.)):
18 N*m (184 kgf*cm, 13 ft.*lbf)
Connect the No. 1 reservoir tube (labeled C) to the master cylinder.
44781D
2.INSTALL RESERVOIR HOSE BRACKET
Install the bracket with the nut.
Install the No. 1 reservoir tube to the clamps of the bracket.
47202
3.INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
Install the nut (labeled A) to the reservoir.
Install the reservoir to the reservoir bracket (labeled B) with the bolt (labeled C).
Install the reservoir bracket (labeled D) to the reservoir with bracket with the 2 nuts (labeled E).
Connect the No. 1 reservoir tube (labeled F) to the reservoir.
Install the reservoir with brackets with the 2 nuts (labeled G).
Connect the brake fluid level warning switch connector (labeled H) to the reservoir.
4.BLEED BRAKE SYSTEM
(See page Brake>BRAKE>BRAKE FLUID>BLEEDING)