Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
04465
1.REMOVE FRONT DISC BRAKE PAD
Remove the 2 disc brake pads.
04945
2.REMOVE ANTI-SQUEAL SHIM KIT FRONT
Remove the shims from each pad.
47771
3.REMOVE NO. 1 PAD WEAR INDICATOR PLATE
Remove the indicator plate from the inner pad.
47716
4.REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
Place tags or marks to identify the installation locations of each plate.
As each pad support plate has its own shape, be sure to identify each one accurately when reinstalling it to prevent improper installation.
Remove the 2 plates from the brake cylinder mounting.
47722
5.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH
Remove the 2 bolts and cylinder mounting.
47715A
6.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN
Remove the 2 pins (upper and lower) from the cylinder mounting.
Using a screwdriver, remove the slide bush from the pin (lower).
Be careful not to damage the pin.
Tape the screwdriver tip before use.
47775
7.REMOVE FRONT DISC BRAKE BUSH DUST BOOT
Remove the 2 boots from the cylinder mounting.
8.REMOVE CYLINDER BOOT
Using a screwdriver, pry out the boot.
Be careful not to damage the brake piston and cylinder.
Tape the screwdriver tip before use.
47731
9.REMOVE FRONT DISC BRAKE PISTON
Place a piece of cloth between the piston and disc brake cylinder.
Apply compressed air to remove the piston from the disc brake cylinder.
Do not place your fingers in front of the piston when applying compressed air.
Be careful not to spatter the brake fluid.
10.REMOVE PISTON SEAL
Using a screwdriver, pry out the seal from the cylinder.
Be careful not to damage the inner cylinder and piston seal groove.
Tape the screwdriver tip before use.
47547B
11.REMOVE FRONT DISC BRAKE BLEEDER PLUG
Remove the bleeder plug cap and bleeder plug from the cylinder.
43512
12.REMOVE FRONT DISC
Put matchmarks on the disc and axle hub.
Remove the disc.