Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEEL
2.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
47313A
3.DISCONNECT FRONT FLEXIBLE HOSE
Remove the union bolt and gasket, and disconnect the front flexible hose from the front disc brake cylinder assembly.
47750
4.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY
Hold the 2 front disc brake cylinder slide pins and remove the 2 bolts and front disc brake cylinder assembly.
| *a | Hold |
| *b | Turn |
Remove the front disc brake cylinder assembly while holding both of the front disc brake pads because the anti-squeal springs may fall off the front disc brake pads.
04465
5.REMOVE FRONT DISC BRAKE PAD
Remove the 2 anti-squeal springs.
Remove the 2 front disc brake pads from the front disc brake cylinder mounting.
04945
6.REMOVE FRONT ANTI-SQUEAL SHIM
Remove the 2 front anti-squeal shims from the front disc brake pads.
47771
7.REMOVE PAD WEAR INDICATOR PLATE
Using a screwdriver, remove the 2 pad wear indicator plates from the front disc brake pads as shown in the illustration.
47716
8.REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
Remove the 4 front disc brake pad support plates from the front disc brake cylinder mounting.
| *1 | Front No. 1 Disc Brake Pad Support Plate |
| *2 | Front No. 2 Disc Brake Pad Support Plate |
| *3 | Front No. 3 Disc Brake Pad Support Plate |
| *4 | Front No. 4 Disc Brake Pad Support Plate |
Each front disc brake pad support plate has a different shape. Be sure to put an identification mark on each front disc brake pad support plate so that they can be reinstalled to their original position.
47715A
9.REMOVE FRONT NO. 1 DISC BRAKE CYLINDER SLIDE PIN
Remove the front No. 1 disc brake cylinder slide pin from the front disc brake cylinder mounting.
47715D
10.REMOVE FRONT NO. 2 DISC BRAKE CYLINDER SLIDE PIN
Remove the front No. 2 disc brake cylinder slide pin from the front disc brake cylinder mounting.
47769
11.REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSHING
Using a screwdriver with its tip wrapped with protective tape, remove the front disc brake cylinder slide bushing from the front No. 2 disc brake cylinder slide pin.
| *a | Protective Tape |
Do not damage the front No. 2 disc brake cylinder slide pin.
47775
12.REMOVE FRONT DISC BRAKE BUSHING DUST BOOT
Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.
47722
13.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING
Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.
43512
14.REMOVE FRONT DISC
Put matchmarks on the front disc and the front axle hub sub-assembly.
| *a | Matchmark |
Remove the front disc.