Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM
RM24M0E _55 Steering _059560 STEERING COLUMN _0291889 STEERING LOCK SYSTEM U

STEERING COLUMN  STEERING LOCK SYSTEM  TERMINALS OF ECU  


CHECK STEERING LOCK ACTUATOR (STEERING LOCK ECU)


B460035E01
3.375,0.104 3.792,0.354 0.417,0.25 3.448,0.146 3.906,0.344 0.458,0.198 10 false G32

a.

Disconnect the G32 steering lock actuator connector.


b.

Measure the voltage and resistance of the wire harness side connector.

Symbols (Terminal No.) Wiring Color Terminal Description Condition Specified Condition
GND (G32-1) - Body ground W-B - Body ground Ground Always Below 1 Ω
SGND (G32-2) - Body ground W-B - Body ground Signal ground Always Below 1 Ω
IG2 (G32-6) - GND (G32-1) B - W-B IG signal input Ignition switch on (IG) 10 to 14 V
B (G32-7) - GND (G32-1) B - W-B Power source Always 10 to 14 V

If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Reconnect the G32 steering lock actuator connector.


d.

Measure the voltage of the connector.

Symbols (Terminal No.) Wiring Color Terminal Description Condition Specified Condition
IGE (G32-3) - GND (G32-1) L - W-B Power source for motor drive Motor operating Below 1 V
Motor not operating 10 to 12 V
SLP1 (G32-4) - SGND (G32-2) Y - W-B Unlock position sensor output signal Steering locked 10 to 14 V
Steering lock released Below 1 V
LIN (G32-5) - SGND (G32-2) GR - W-B LIN communication bus Ignition switch on (IG) Pulse generation

If the result is not as specified, there may be a malfunction on the wire harness side.