Home › Steering › POWER STEERING › POWER STEERING SYSTEM › from 2014.09
RM24M0E _55 Steering _059561 POWER STEERING _0291895 POWER STEERING SYSTEM D

POWER STEERING  POWER STEERING SYSTEM  CALIBRATION  


ROTATION ANGLE SENSOR INITIALIZATION AND TORQUE SENSOR ZERO POINT CALIBRATION


NOTICE:

Clear the rotation angle sensor calibration value, initialize the rotation angle sensor, and calibrate the torque sensor zero point if any of the following has occurred:

·

The power steering ECU has been replaced.

·

The power steering link has been replaced.

·

Steering effort differs between left and right.



a.

Inspection before calibration

i.
B135940E01
0.425,2.845 1.557,3.021 1.132,0.177 10 Intelligent Tester 0.6,2.589 0.6,2.832 false 1.48,2.058 1.864,2.214 0.385,0.156 10 DLC3 1.717,2.051 1.841,1.732 false

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch on (IG).


iii.

Turn the intelligent tester on.


iv.

Select "IG Power Supply" from the Data List.


v.

Check the IG power supply voltage on the tester screen.

Power steering ECU
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
IG Power Supply ECU power source voltage / Min.: 0 V, Max.: 36 V 10 to 14 V Ignition switch on (IG)

Standard voltage:

10 to 14 V


NOTICE:

If the IG power supply voltage is 9 V or less, calibration cannot be performed. In this case, charge or replace the battery, and then perform calibration.




b.

Rotation angle sensor calibration value clear, rotation angle sensor initialization, and torque sensor zero point calibration.

NOTICE:
·

If DTC C1516 (Torque Sensor Zero Point Adjustment Incomplete) is stored, the torque sensor zero point cannot be calibrated. Clear the DTC before starting calibration.

·

If DTC C1526 (Rotation Angle Sensor Initialization Incomplete) is stored, the rotation angle sensor cannot be initialized. Clear the DTC before starting initialization.



i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch on (IG).


iii.

Turn the intelligent tester on.


iv.

Select "Utility".


v.

Selected "Torque Sensor Adjustment".

NOTICE:
·

Set the steering wheel to the center point and align the front tires straight ahead.

·

Do not turn the steering wheel sharply.

·

Do not touch the steering wheel during the torque sensor zero point calibration (for 3 seconds).