Home › Steering › POWER STEERING › STEERING GEAR
RM24M0E _55 Steering _059561 POWER STEERING _0291897 STEERING GEAR G

POWER STEERING  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 45407 1.INSPECT TIE ROD END SUB-ASSEMBLY LH

a.
ZK08184

Move the ball joint stud back and forth 5 times as shown in the illustration, before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

Standard turning torque:

0.98 to 3.92 N*m (9.6 to 38.4 kgf*cm, 8.67 to 34.7 in.*lbf)



Hide 45046 2.INSPECT TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedures described for the LH side.


Hide 3.INSPECT TOTAL PRELOAD

a.
C367873E01
0.885,1.219 1.219,1.219 false 0.563,1.135 1.021,1.333 0.458,0.198 10 false SST

Temporarily install the left and right steering rack ends to prevent steering rack overstroke.


b.

Using SST and a torque wrench, inspect the preload.

SST
09616-00011  

Standard preload:

0.7 to 1.25 N*m (7.1 to 12.7 kgf*cm, 6.2 to 11.06 in.*lbf)


HINT:

If the preload is not as specified, replace the new power steering gear assembly.