READ DATA LIST
Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Read the Data List according to the display on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Passenger Detection | Passenger detection / NG, NONE, DETECT or FAIL | NG: Data is not determined
NONE: No passenger DETECT: Exist passenger FAIL: Failure detected |
- |
| Driver Buckle SW | Driver side Buckle SW / UNSET, SET or NG | UNSET: The seat belt is not fastened
SET: The seat belt is fastened NG: Data is not determined |
- |
| Left side Buckle SW | Left side Buckle SW / UNSET, SET or NG | UNSET: The seat belt is not fastened
SET: The seat belt is fastened NG: Data is not determined |
- |
| Passenger Buckle SW | Passenger side Buckle SW / UNSET, SET or NG | UNSET: The seat belt is not fastened
SET: The seat belt is fastened NG: Data is not determined |
- |
| Right side Buckle SW | Right side Buckle SW / UNSET, SET or NG | UNSET: The seat belt is not fastened
SET: The seat belt is fastened NG: Data is not determined |
- |
| Disp Typ | Display Type Information / LR or DP | LR: Display is indicated by LH/RH
DP: Display is indicated by Driver/Passenger |
- |