73230
1.INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
w/o Pre-crash Safety System:
w/o Front Seat Side Airbag and Seat Heater:
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A7 (+) - B1 | Seat belt is fastened | Below 1 Ω |
| Seat belt is unfastened | ||
| A1 (E) - B3 | Seat belt is fastened | 1 MΩ or higher |
| Seat belt is unfastened | Below 1 Ω |
If the result is not as specified, replace the inner belt assembly.
w/ Front Seat Side Airbag and Seat Heater:
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A2 (+) - B1 | Seat belt is fastened | Below 1 Ω |
| Seat belt is unfastened | ||
| A1 (E) - B3 | Seat belt is fastened | 1 MΩ or higher |
| Seat belt is unfastened | Below 1 Ω |
If the result is not as specified, replace the inner belt assembly.
w/ Pre-crash Safety System:
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A2 (+) - B1 | Seat belt is fastened | Below 1 Ω |
| Seat belt is unfastened | ||
| A4 (RBE-) - A3 (E) | Seat belt is fastened | 1 kΩ to 1.6 kΩ |
| Seat belt is unfastened | 100 Ω to 500 Ω | |
| A3 (E) - B3 | Seat belt is fastened | Below 1 Ω |
| Seat belt is unfastened |
If the result is not as specified, replace the inner belt assembly.
2.INSPECT FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR)
Measure the resistance of the sensor.
| Condition | Specified Condition |
|---|---|
| Apply more than 29 N (3 kgf, 71 lbf) to occupant detection sensor | Below 100 Ω |
| Seat not occupied | 1 MΩ or higher |
If the result is not as specified, replace the front seat cushion pad.
73240
3.INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
w/o Pre-crash Safety System:
for Manual Seat, w/o Front Seat Side Airbag and Seat Heater:
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A7 (RDC) - A1 (E) | Seat belt is fastened | 1 MΩ or higher |
| Seat belt is unfastened | Below 1 Ω |
If the result is not as specified, replace the inner belt assembly.
for Power Seat or Manual Seat w/ Front Seat Side Airbag or Seat Heater:
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A2 (+) - A1 (E) | Seat belt is fastened | 1 MΩ or higher |
| Seat belt is unfastened | Below 1 Ω |
If the result is not as specified, replace the inner belt assembly.
w/ Pre-crash Safety System:
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A4 (RBE-) - A3 (E) | Seat belt is fastened | 1 kΩ to 1.6 kΩ |
| Seat belt is unfastened | 100 Ω to 500 Ω | |
| A2 (+) - B3 | Seat belt is fastened | 1 MΩ or higher |
| Seat belt is unfastened | Below 1 Ω |
If the result is not as specified, replace the inner belt assembly.