73230
1.INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Passenger Side)
for RHD
w/o Front Seat Side Airbag:
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M30-7 (+) - B-1 | Always | Below 1 Ω |
| M30-1 (E) - B-3 | Seat belt is fastened | 1 MΩ or higher |
| Seat belt is unfastened | Below 1 Ω |
If the result is not as specified, replace the front seat inner belt assembly (for passenger side).
w/ Front Seat Side Airbag:
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| X12-2 (+) - B-1 | Always | Below 1 Ω |
| X12-1 (E) - B-3 | Seat belt is fastened | 1 MΩ or higher |
| Seat belt is unfastened | Below 1 Ω |
If the result is not as specified, replace the front seat inner belt assembly (for passenger side).
for LHD
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| W12-2 (+) - B-1 | Always | Below 1 Ω |
| W12-1 (E) - B-3 | Seat belt is fastened | 1 MΩ or higher |
| Seat belt is unfastened | Below 1 Ω |
If the result is not as specified, replace the front seat inner belt assembly (for passenger side).
2.INSPECT OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)
Measure the resistance of the sensor.
| Condition | Specified Condition |
|---|---|
| Apply more than 29 N (3 kgf, 71 lbf) to occupant detection sensor | Below 100 Ω |
| Seat not occupied | 1 MΩ or higher |
If the result is not as specified, replace the occupant detection sensor (separate type front seat cushion pad).
73240
3.INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 - 1 | Seat belt is fastened | 1 MΩ or higher |
| Seat belt is unfastened | Below 1 Ω |
If the result is not as specified, replace the front seat inner belt assembly (for driver side).