Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM(except LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291933 LIGHTING SYSTEM(except LED Headlight) C

LIGHTING  LIGHTING SYSTEM(except LED Headlight)  B2410  Headlight Swivel ECU LH Communication Malfunction  B2411  Headlight Swivel ECU RH Communication Malfunction  


DESCRIPTION

The AFS ECU operates the headlight swivel motor in accordance with the vehicle speed and steering angle.

The AFS ECU also receives information from the headlight swivel motor.

DTC No. DTC Detection Condition Trouble Area
B2410 AFS ECU cannot communicate with headlight swivel motor LH normally for 1 second or more
·

Headlight assembly LH (Headlight swivel motor LH)

·

AFS ECU

·

Wire harness


B2411 AFS ECU cannot communicate with headlight swivel motor RH normally for 1 second or more
·

Headlight assembly RH (Headlight swivel motor RH)

·

AFS ECU

·

Wire harness



WIRING DIAGRAM

E132265E01
5.334,6.89 6.349,7.043 1.015,0.153 10 A28 5.334,7.05 6.349,7.203 1.015,0.153 10 AFS ECU 1.13,1.932 2.144,2.084 1.015,0.153 10 B2 4.838,0.504 5.306,0.657 0.469,0.153 10 SMBL 4.838,0.965 5.306,1.118 0.469,0.153 10 SML 4.838,1.427 5.306,1.580 0.469,0.153 10 SMGL 4.641,0.638 4.745,0.791 0.104,0.153 10 1 4.558,1.1 4.755,1.253 0.197,0.153 10 29 4.558,1.561 4.745,1.714 0.186,0.153 10 23 2.364,0.504 2.832,0.657 0.469,0.153 10 SMBL 2.364,0.965 2.832,1.118 0.469,0.153 10 SBLL 2.364,1.427 2.832,1.580 0.469,0.153 10 SBGL 2.935,0.638 3.039,0.791 0.104,0.153 10 3 2.935,1.1 3.039,1.253 0.104,0.153 10 2 2.935,1.561 3.039,1.714 0.104,0.153 10 1 2.364,3.625 2.832,3.778 0.469,0.153 10 SMBR 2.364,4.087 2.832,4.240 0.469,0.153 10 SBLR 2.364,4.548 2.832,4.701 0.469,0.153 10 SBGR 2.935,3.76 3.039,3.913 0.104,0.153 10 3 2.935,4.221 3.039,4.374 0.104,0.153 10 2 2.935,4.683 3.039,4.836 0.104,0.153 10 1 4.838,3.625 5.306,3.778 0.469,0.153 10 SMBR 4.838,4.087 5.306,4.240 0.469,0.153 10 SMR 4.838,4.548 5.306,4.701 0.469,0.153 10 SMGR 4.6,3.76 4.714,3.913 0.115,0.153 10 2 4.548,4.221 4.734,4.374 0.186,0.153 10 10 4.548,4.683 4.745,4.836 0.197,0.153 10 24 4.838,6.03 5.306,6.182 0.469,0.153 10 IGS 4.838,6.491 5.306,6.644 0.469,0.153 10 E1 4.548,6.164 4.734,6.317 0.186,0.153 10 14 3.028,6.164 3.814,6.317 0.786,0.153 10 LH ECU-IG 4.548,6.626 4.745,6.779 0.197,0.153 10 22 1.13,2.091 2.765,2.244 1.635,0.153 10 Headlight LH 0.863,0.354 1.506,0.835 0.642,0.481 10 Headlight Swivel Motor 0.863,3.479 1.506,3.959 0.642,0.481 10 Headlight Swivel Motor 1.13,5.078 2.144,5.230 1.015,0.153 10 B17 1.13,5.237 2.765,5.390 1.635,0.153 10 Headlight RH 1.587,5.994 2.375,6.147 0.788,0.153 10 from Battery

PROCEDURE

1.INSPECT FUSE (LH ECU-IG)
a.

Remove the LH ECU-IG fuse from the main body ECU.


b.

Measure the resistance of the fuse.

Standard Resistance:

Below 1 Ω




OK

2.CHECK WIRE HARNESS (AFS ECU - BATTERY AND BODY GROUND)

NG

REPLACE FUSE

2.CHECK WIRE HARNESS (AFS ECU - BATTERY AND BODY GROUND)
a.
U189879E01
0.038,0.063 1.403,0.219 1.364,0.156 10 Wire Harness Side: 1.639,0.534 1.934,0.672 0.295,0.138 10 A28 0.211,1.836 0.505,1.974 0.295,0.138 10 IGS 1.444,1.836 1.739,1.974 0.295,0.138 10 E1 0.357,1.41 0.357,1.822 false 1.565,1.41 1.565,1.822 false

Disconnect the A28 ECU connector.


b.

Measure the voltage and resistance of the wire harness side connector.

Standard Voltage:
Tester Connection Condition Specified Condition
A28-14 (IGS) - Body ground Engine switch on (IG) 11 to 14 V


Standard Resistance:
Tester Connection Specified Condition
A28-22 (E1) - Body ground Below 1 Ω




OK

3.CHECK WIRE HARNESS (AFS ECU - HEADLIGHT (HEADLIGHT SWIVEL MOTOR))

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK WIRE HARNESS (AFS ECU - HEADLIGHT (HEADLIGHT SWIVEL MOTOR))
a.

Disconnect the A28 ECU connector.


b.

Disconnect the B2 (for LH) and B17 (for RH) swivel motor connector.


c.

Measure the resistance of the wire harness side connectors.

Standard Resistance:
for LH
Tester Connection Specified Condition
A28-1 (SMBL) - B2-3 (SMBL) Below 1 Ω
A28-23 (SMGL) - B2-1 (SBGL) Below 1 Ω
A28-29 (SML) - B2-2 (SBLL) Below 1 Ω
A28-1 (SMBL) or B2-3 (SMBL) - Body ground 10 kΩ or higher
A28-23 (SMGL) or B2-1 (SBGL) - Body ground 10 kΩ or higher
A28-29 (SML) or B2-2 (SBLL) - Body ground 10 kΩ or higher

for RH
Tester Connection Specified Condition
A28-2 (SMBR) - B17-3 (SMBR) Below 1 Ω
A28-24 (SMGR) - B17-1 (SBGR) Below 1 Ω
A28-10 (SMR) - B17-2 (SBLR) Below 1 Ω
A28-2 (SMBR) or B17-3 (SMBR) - Body ground 10 kΩ or higher
A28-24 (SMGR) or B17-1 (SBGR) - Body ground 10 kΩ or higher
A28-10 (SMR) or B17-2 (SBLR) - Body ground 10 kΩ or higher




OK

4.CHECK AFS ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK AFS ECU
a.
E130953E01
2.83,0.425 3.245,0.580 0.415,0.156 10 SMBL 2.141,0.425 2.576,0.580 0.435,0.156 10 SMBR 1.145,1.822 1.595,1.977 0.451,0.156 10 SMGR 1.831,1.822 2.266,1.977 0.435,0.156 10 SMGL 2.903,1.115 3.065,0.631 false 1.436,1.795 1.599,1.31 false 2.762,1.115 2.446,0.631 false 2.043,1.791 1.727,1.307 false

Reconnect the A28 ECU connector.


b.

Measure the voltage and resistance of the connector.

Standard Voltage:
for LH
Tester Connection Condition Specified Condition
1 (SMBL) - Body ground Engine switch on (IG) 11 to 14 V

for RH
Tester Connection Condition Specified Condition
2 (SMBR) - Body ground Engine switch on (IG) 11 to 14 V


Standard Resistance:
for LH
Tester Connection Specified Condition
23 (SMGL) - Body ground Below 1 Ω

for RH
Tester Connection Specified Condition
24 (SMGR) - Body ground Below 1 Ω




OK

5.REPLACE HEADLIGHT ASSEMBLY (HEADLIGHT SWIVEL MOTOR)

NG

6.REPLACE AFS ECU
5.REPLACE HEADLIGHT ASSEMBLY (HEADLIGHT SWIVEL MOTOR)
a.

Replace the headlight LH or RH with a new one.


b.

Check for DTCs again.

Result
Result Proceed to
DTC is not output A
DTC is output B



A

END

B

6.REPLACE AFS ECU
6.REPLACE AFS ECU

NEXT

7.PERFORM INITIALIZATION
7.PERFORM INITIALIZATION

NEXT

END