Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM(except LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291933 LIGHTING SYSTEM(except LED Headlight) C

LIGHTING  LIGHTING SYSTEM(except LED Headlight)  B2417  Headlight Beam Level Control Motor LH Malfunction  B2418  Headlight Beam Level Control Motor RH Malfunction  


DESCRIPTION

The AFS ECU operates the headlight leveling motor in accordance with the vehicle height.

The AFS ECU also receives information from the headlight leveling motor.

DTC No. DTC Detection Condition Trouble Area
B2417 When one of following conditions is met:
·

Open or short between AFS ECU and headlight leveling motor LH

·

Abnormal headlight leveling motor LH power supply voltage

·

Headlight leveling motor LH gear faulty


·

Headlight leveling motor LH

·

AFS ECU

·

Wire harness


B2418 When one of following conditions is met:
·

Open or short between AFS ECU and headlight leveling motor RH

·

Abnormal headlight leveling motor RH power supply voltage

·

Headlight leveling motor RH gear faulty


·

Headlight leveling motor RH

·

AFS ECU

·

Wire harness



WIRING DIAGRAM

E132269E01
5.327,5.991 6.342,6.144 1.015,0.153 10 A28 5.327,6.151 6.342,6.304 1.015,0.153 10 AFS ECU 0.994,1.378 2.009,1.531 1.015,0.153 10 B3 4.826,0.511 5.294,0.664 0.469,0.153 10 LL1+ 4.826,0.972 5.294,1.125 0.469,0.153 10 LL1- 4.617,0.645 4.719,0.798 0.102,0.153 10 3 4.546,1.107 4.733,1.260 0.186,0.153 10 27 2.352,0.511 2.820,0.664 0.469,0.153 10 LHIG 2.352,0.972 2.820,1.125 0.469,0.153 10 LH E 2.935,0.645 3.039,0.798 0.104,0.153 10 1 2.935,1.107 3.039,1.260 0.104,0.153 10 3 2.352,2.736 2.820,2.889 0.469,0.153 10 RHIG 2.352,3.198 2.820,3.351 0.469,0.153 10 RH E 2.935,2.871 3.039,3.024 0.104,0.153 10 1 2.935,3.332 3.039,3.485 0.104,0.153 10 3 4.826,2.736 5.294,2.889 0.469,0.153 10 LR1+ 4.826,3.198 5.294,3.351 0.469,0.153 10 LR1- 4.588,2.871 4.702,3.024 0.115,0.153 10 4 4.536,3.332 4.722,3.485 0.186,0.153 10 28 4.83,5.131 5.299,5.284 0.469,0.153 10 IG 4.83,5.569 5.299,5.722 0.469,0.153 10 E1 4.541,5.266 4.727,5.418 0.186,0.153 10 15 2.951,5.266 3.920,5.418 0.969,0.153 10 GAUGE NO. 1 4.541,5.703 4.737,5.856 0.197,0.153 10 22 0.994,1.538 2.848,1.705 1.854,0.168 10 Headlight Leveling Motor LH 0.994,3.601 2.009,3.754 1.015,0.153 10 B18 0.994,3.761 2.848,3.929 1.854,0.168 10 Headlight Leveling Motor RH 1.58,5.095 2.368,5.248 0.788,0.153 10 from Battery

PROCEDURE

1.INSPECT FUSE (GAUGE NO. 1)
a.

Remove the GAUGE NO. 1 fuse from the main body ECU.


b.

Measure the resistance of the fuse.

Standard Resistance:

Below 1 Ω




OK

2.CHECK WIRE HARNESS (AFS ECU - BATTERY AND BODY GROUND)

NG

REPLACE FUSE

2.CHECK WIRE HARNESS (AFS ECU - BATTERY AND BODY GROUND)
a.
U189880E01
0.038,0.063 1.403,0.219 1.364,0.156 10 Wire Harness Side: 1.639,0.534 1.934,0.672 0.295,0.138 10 A28 0.415,1.836 0.710,1.974 0.295,0.138 10 IG 1.444,1.836 1.739,1.974 0.295,0.138 10 E1 0.499,1.41 0.499,1.822 false 1.565,1.41 1.565,1.822 false

Disconnect the A28 ECU connector.


b.

Measure the voltage and resistance of the wire harness side connector.

Standard Voltage:
Tester Connection Condition Specified Condition
A28-15 (IG) - Body ground Engine switch on (IG) 11 to 14 V


Standard Resistance:
Tester Connection Specified Condition
A28-22 (E1) - Body ground Below 1 Ω




OK

3.CHECK WIRE HARNESS (AFS ECU - HEADLIGHT LEVELING MOTOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK WIRE HARNESS (AFS ECU - HEADLIGHT LEVELING MOTOR)
a.

Disconnect the A28 ECU connector.


b.

Disconnect the B3 (for LH) and B18 (for RH) leveling motor connector.


c.

Measure the resistance of the wire harness side connectors.

Standard Resistance:
for LH
Tester Connection Specified Condition
A28-3 (LL1+) - B3-1 (LHIG) Below 1 Ω
A28-27 (LL1-) - B3-3 (LH E) Below 1 Ω
A28-3 (LL1+) or B3-1 (LHIG) - Body ground 10 kΩ or higher
A28-27 (LL1-) or B3-3 (LH E) - Body ground 10 kΩ or higher

for RH
Tester Connection Specified Condition
A28-4 (LR1+) - B18-1 (RHIG) Below 1 Ω
A28-28 (LR1-) - B18-3 (RH E) Below 1 Ω
A28-4 (LR1+) or B18-1 (RHIG) - Body ground 10 kΩ or higher
A28-28 (LR1-) or B18-3 (RH E) - Body ground 10 kΩ or higher




OK

4.CHECK AFS ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK AFS ECU
a.
E130953E03
2.566,0.425 2.981,0.580 0.415,0.156 10 LL1+ 1.877,0.425 2.312,0.580 0.435,0.156 10 LR1+ 0.644,1.822 1.094,1.977 0.451,0.156 10 LR1- 1.306,1.822 1.740,1.977 0.435,0.156 10 LL1- 2.639,1.115 2.801,0.631 false 0.911,1.795 1.073,1.31 false 2.498,1.115 2.182,0.631 false 1.517,1.791 1.201,1.307 false

Reconnect the A28 ECU connector.


b.

Measure the voltage and resistance of the connector.

Standard Voltage:
for LH
Tester Connection Condition Specified Condition
3 (LL1+) - Body ground Engine switch on (IG) 11 to 14 V

for RH
Tester Connection Condition Specified Condition
4 (LR1+) - Body ground Engine switch on (IG) 11 to 14 V


Standard Resistance:
for LH
Tester Connection Specified Condition
27 (LL1-) - Body ground Below 1 Ω

for RH
Tester Connection Specified Condition
28 (LR1-) - Body ground Below 1 Ω




OK

5.REPLACE HEADLIGHT LEVELING MOTOR

NG

6.REPLACE AFS ECU
5.REPLACE HEADLIGHT LEVELING MOTOR
a.

Replace the headlight leveling motor LH or RH with a new one.


b.

Check for DTCs again.

Result
Result Proceed to
DTC is not output A
DTC is output B



A

END

B

6.REPLACE AFS ECU
6.REPLACE AFS ECU

NEXT

7.PERFORM INITIALIZATION
7.PERFORM INITIALIZATION

NEXT

END