AFS
OUTLINE:
The AFS (Intelligent Adaptive Front-lighting System) is a system in which the low-beam headlights swivel vertically and horizontally in accordance with the vehicle speed and steering angle to provide optimal illumination of the road.
SYSTEM OPERATION:
| Running condition | Headlight LH (Lo) | Headlight RH (Lo) |
|---|---|---|
| When vehicle is cornering right
(10 to 30 km/h) |
Does not swivel | Swivels right by maximum of 15° |
| When vehicle is cornering left
(10 to 30 km/h) |
Swivels left by maximum of 10° | Does not swivel |
| When vehicle is cornering right
(30 km/h or more) |
Swivels right by maximum of 7.5° | Swivels right by maximum of 15° |
| When vehicle is cornering left
(30 km/h or more) |
Swivels left by maximum of 10° | Swivels left by maximum of 5° |
OPERATION START CONDITION:
When all of the following conditions are met, the system starts operating.
| Engine | Running |
| Shift position | Forward position |
| Headlight | HEAD position |
| Vehicle speed | 10 km/h or more |
| Steering angle | 27° or more (10 to 60 km/h)
7.5° or more (60 km/h or more) |
| AFS OFF switch | OFF |
The steering angle by which the system starts operating varies depending on the vehicle speed.
If the system starts operating once the vehicle speed exceeds 10 km/h, the system will continue operating even if the vehicle speed decreases, as long as the vehicle speed is 5 km/h or more.
OPERATION STOP CONDITION:
When one of the following conditions is met, the system stops operating.
| Engine | Stopped |
| Shift position | Except forward position |
| Headlight | OFF |
| Vehicle speed | Less than 5 km/h |
| Steering angle | 7.5° or less |
| AFS OFF switch | ON |
LIGHTING SYSTEM
Illumination control function (Illuminated entry function):
When the doors are unlocked through a key or transmitter operation, or when a door is opened or closed, the illuminated entry function turns on the map light, room light, engine switch light and inside handle illumination light.
The main body ECU receives the following signals (A).
Door courtesy switch signal
Door detection switch signal
Engine switch signal
The main body ECU controls the following signal based on the signals listed in A.
Illumination operation signal
The main body ECU controls the on/off and fade-in/fade-out operation of the following parts.
Map light
Room light
Inside handle illumination light
Engine switch light
Battery saver function:
When the engine switch is turned off and any of the doors is open continuously for 20 minutes, the main body ECU turns the illumination operation signal off. As a result, the map light, the room light and the inside handle illumination light turn off.
The main body ECU receives the following signals (B).
Door courtesy switch signal
Engine switch signal
The main body ECU controls the following signal based on the signals listed in B (C).
Illumination operation signal
The main body ECU controls the illumination period of the following parts based on the signals listed in C.
Map light
Room light
Inside handle illumination light
Manual light control:
When lights such as the headlights and taillights are illuminated through manual operation of the headlight dimmer switch (light control switch).
The main body ECU receives the following signals (D).
Headlight dimmer switch signal (light control switch, front fog light switch, rear fog light switch)
The main body ECU controls the following signals based on the signals listed in D (E).
Headlight relay operation signal
Taillight relay operation signal
Headlight dimmer relay operation signal
Front fog light relay operation signal
Rear fog light relay operation signal
Panel relay operation signal
The main body ECU controls the on/off operation of the following parts based on the signals listed in E.
Headlight (Low)
Headlight (Hi)
Clearance light
Front fog light
Rear fog light
Light auto turn off function:
With the headlight dimmer switch (light control switch) in the TAIL or HEAD position, turning the engine switch off and opening any door (except the luggage compartment door) automatically turns off the taillights or headlights.
The main body ECU receives the following items (F).
Engine speed
Engine switch signal
The main body ECU controls the following signals based on the items listed in F (G).
Headlight relay operation signal
Taillight relay operation signal
Front fog light relay operation signal
Rear fog light relay operation signal
The main body ECU controls the illumination period of the following parts based on the signals listed in G.
Headlight (Low)
Headlight (Hi)
Clearance light (front and rear)
Front fog light
Rear fog light
Automatic light control function:
When the automatic light control sensor is ON while the vehicle is being driven and the headlight dimmer switch (light control switch) is in the AUTO position, the headlights and taillights automatically illuminate. When this system is operating with the lights ON, turning the engine switch off and opening the driver's door turns off the lights.
The main body ECU receives the following signals (H).
Door courtesy switch signal
Automatic light control sensor signal
Headlight dimmer switch (Light control switch) signal
The main body ECU controls the following signals based on the signals listed in H (I).
Headlight relay operation signal
Taillight relay operation signal
The main body ECU controls the illumination period of the following parts based on the signals listed in I.
Headlight
Taillight
Clearance light