Home › Vehicle Interior › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY(except LED Headlight) › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291937 REAR COMBINATION LIGHT ASSEMBLY(except LED Headlight) A

LIGHTING  REAR COMBINATION LIGHT ASSEMBLY(except LED Headlight)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 81560 2.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH

B460064

a.

Remove the 2 screws.


b.

Detach the clip and disconnect the connector.


c.

Remove the rear combination light.


Hide 67939D 3.REMOVE BACK DOOR GARNISH CENTER

Hide 67848 4.REMOVE BACK DOOR SERVICE HOLE COVER LH (for Power Back Door)

Hide 62582H 5.REMOVE REAR WINDOW SIDE GARNISH LH

Hide 62581H 6.REMOVE REAR WINDOW SIDE GARNISH RH

Hide 67750 7.REMOVE BACK DOOR TRIM BOARD ASSEMBLY

Hide 84280D 8.REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH (for Power Back Door)

Hide 81590A 9.REMOVE REAR LIGHT ASSEMBLY LH

E130641

a.

Disconnect the connector.


b.

Remove the 3 nuts.


c.
B146707E01
0.595,3.158 1.017,3.325 0.423,0.167 10 Clamp

Detach the pin and remove the rear light.