Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.
81564
1.REMOVE REAR COMBINATION LIGHT BODY GASKET LH
Remove the rear combination light body gasket.
81550L
2.REMOVE REAR TURN SIGNAL LIGHT BULB
Detach the 2 clamps.
Turn the bulb in the direction indicated by the arrows and pull to remove it.
Remove the bulb from the socket.
81550M
3.REMOVE REAR TURN SIGNAL LIGHT SOCKET
Disconnect the connector and rear turn signal socket.
81594A
4.REMOVE REAR LIGHT GASKET LH
Remove the rear light gasket.
81550N
5.REMOVE BACK UP LIGHT BULB
Detach the clamps.
Turn the bulb in the direction indicated by the arrows and pull to remove them it.
Remove the bulb from the socket.
81585
6.REMOVE REAR LIGHT SOCKET AND WIRE
for "TORX" screw Type:
Using a "TORX" socket T20, remove the 2 screws and cover.
for Tamper Resistant "TORX" Screw Type:
Using a "TORX" Driver T20H, remove the 2 screws and cover.
Disconnect the connector and rear light socket and wire.