Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.
81585
1.INSTALL REAR LIGHT SOCKET AND WIRE
Connect the connector and rear light and wire.
for "TORX" Screw Type:
Using a "TORX" socket T20, install the 2 screws and cover.
for Tamper Resistant "TORX" Screw Type:
Using a "TORX" Driver T20H, install the 2 screws and cover.
81550N
2.INSTALL BACK UP LIGHT BULB
Install the bulb to the socket.
Turn the bulb/socket unit in the direction indicated by the arrow to install it.
Install the 2 clamps.
81594A
3.INSTALL REAR LIGHT GASKET LH
Install a new rear light gasket.
81550M
4.INSTALL REAR TURN SIGNAL LIGHT SOCKET
Connect the connector and install the rear turn signal socket.
81550L
5.INSTALL REAR TURN SIGNAL BULB
Install the bulb to the socket.
Turn the bulb/socket unit in the direction indicated by the arrow to install it.
Install the 2 clamps.
81564
6.INSTALL REAR COMBINATION LIGHT BODY GASKET LH
Install a new rear combination light body gasket.