Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81110D
1.REMOVE NO. 2 HEADLIGHT BULB
Turn the No. 2 headlight bulb in the direction indicated by the arrow shown in the illustration, and remove it.
Do not touch the bulb glass.
81139
2.REMOVE HEADLIGHT SOCKET COVER
Turn the headlight socket cover in the direction indicated by the arrow shown in the illustration, and remove it.
81110B
3.REMOVE NO. 1 HEADLIGHT BULB (w/o AFS)
Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration, and remove it.
Do not touch the bulb glass.
81110L
4.REMOVE DISCHARGE HEADLIGHT BULB (w/ AFS)
Turn the light control ECU socket in the direction indicated by the arrow shown in the illustration, and separate it.
Release the set spring and remove the discharge headlight bulb in the direction indicated by the arrow shown in the illustration.
Do not touch the bulb glass.
81610F
5.REMOVE CLEARANCE LIGHT BULB
Turn the clearance light bulb and clearance light socket in the direction indicated by the arrow shown in the illustration, and remove them as a unit.
Remove the clearance light bulb from the clearance light socket.
81510C
6.REMOVE FRONT TURN SIGNAL LIGHT BULB
Turn the front turn signal light bulb and front turn signal light socket in the direction indicated by the arrow shown in the illustration, and remove them as a unit.
Remove the front turn signal light bulb from the front turn signal light socket.
81108
7.REMOVE LIGHT CONTROL ECU SUB-ASSEMBLY (w/ AFS)
Remove the 4 screws.
Remove the 3 screws.
Disconnect the connector and remove the headlight reflector.
Disconnect the connector and remove the light control ECU sub-assembly.
81134
8.REMOVE HEADLIGHT GASKET (w/ AFS)
Remove the headlight gasket.
After the headlight gasket base packing is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.
85662
9.REMOVE HEADLIGHT LEVELING MOTOR (w/o AFS)
Rotate the headlight leveling motor in the direction indicated by the arrow in the illustration.
Rotate the aiming screw on the headlight leveling motor in the direction indicated by the arrow (1) in the illustration and remove the shaft.
Pull the headlight leveling motor out to remove it.
85662
10.REMOVE HEADLIGHT LEVELING MOTOR (w/ AFS)
Align the notches of the headlight leveling motor and the housing, and pull out the headlight leveling motor slightly.
Lower the tip of the headlight leveling motor to disengage it from the reflector and remove the headlight leveling motor.
85669
11.REMOVE HEADLIGHT LEVELING MOTOR BASE PACKING
Remove the headlight leveling motor base packing.
After the headlight leveling motor base packing is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.
81125
12.REMOVE HEADLIGHT CORD
Remove the headlight cord.
81165
13.REMOVE HEADLIGHT CORD (w/ AFS)
Remove the headlight cord.