Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81165
1.INSTALL HEADLIGHT CORD (w/ AFS)
Install the headlight cord.
81125
2.INSTALL HEADLIGHT CORD
Install the headlight cord.
85669
3.INSTALL HEADLIGHT LEVELING MOTOR BASE PACKING
Install a new headlight leveling motor base packing.
85662
4.INSTALL HEADLIGHT LEVELING MOTOR (w/ AFS)
Engage the tip of the headlight leveling motor with the reflector.
Turn the headlight leveling motor in the direction indicated by the arrow in the illustration to install it.
85662
5.INSTALL HEADLIGHT LEVELING MOTOR (w/o AFS)
Rotate the aiming screw on the headlight leveling motor in the direction indicated by the arrow in the illustration and install the shaft.
Rotate the headlight leveling motor in the direction indicated by the arrow in the illustration to install it.
81134
6.INSTALL HEADLIGHT GASKET (w/ AFS)
Install a new headlight gasket.
81108
7.INSTALL LIGHT CONTROL ECU SUB-ASSEMBLY (w/ AFS)
Connect the connector.
Insert the socket part of the light control ECU sub-assembly to the location shown in the illustration.
Install the headlight reflector with the 3 screws.
Connect the connector.
Install the light control ECU sub-assembly with the 4 screws.
81610F
8.INSTALL CLEARANCE LIGHT BULB
Install the clearance light bulb to the clearance light socket.
Turn the clearance light bulb and clearance light socket in the direction indicated by the arrow shown in the illustration to install them as a unit.
81510C
9.INSTALL FRONT TURN SIGNAL LIGHT BULB
Install the front turn signal light bulb to the front turn signal light socket.
Turn the front turn signal light bulb and front turn signal light socket in the direction indicated by the arrow shown in the illustration to install them as a unit.
81110L
10.INSTALL DISCHARGE HEADLIGHT BULB (w/ AFS)
Lock the set spring to install the discharge headlight bulb in the direction indicated by the arrow shown in the illustration.
Do not touch the bulb glass.
Turn the light control ECU socket in the direction indicated by the arrow shown in the illustration to connect it.
81110B
11.INSTALL NO. 1 HEADLIGHT BULB (w/o AFS)
Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.
Do not touch the bulb glass.
81139
12.INSTALL HEADLIGHT SOCKET COVER
Install the headlight socket cover and turn it clockwise to complete the installation.
81110D
13.INSTALL NO. 2 HEADLIGHT BULB
Turn the No. 2 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.
Do not touch the bulb glass.