Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
74320
2.REMOVE VISOR ASSEMBLY LH
Using a screwdriver, detach the 4 claws and remove the visor bracket cover.
Tape the screwdriver tip before use.
Remove portion A from the visor holder.
Detach the 2 claws and remove the visor.
81340
3.REMOVE VANITY LIGHT ASSEMBLY
Using a screwdriver, pry out the vanity light assembly.
Tape the screwdriver tip before use.
Detach the 2 claws and vanity light.
81340B
4.REMOVE VANITY LIGHT BULB
Remove the light bulb from the vanity light.