85916D
1.INSPECT FRONT FOG LIGHT RELAY (Marking: FOG)
Remove the front fog light relay from the engine room No. 2 relay block.
Measure the resistance of the relay.
| Tester Connection | Specified Condition |
|---|---|
| 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
If the result is not as specified, replace the relay.
85916L
2.INSPECT REAR FOG LIGHT RELAY (Marking: RR FOG)
Remove the rear fog light relay from the fusible link block.
Measure the resistance of the relay.
| Tester Connection | Specified Condition |
|---|---|
| 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
If the result is not as specified, replace the relay.