Home › Vehicle Interior › LIGHTING › HAZARD WARNING SWITCH › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291947 HAZARD WARNING SWITCH G

LIGHTING  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84975 1.INSPECT TRIP SWITCH (for LHD)

E127509E16
0.369,0.189 0.609,0.361 0.240,0.172 10 *a

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 - 6 ODO TRIP switch not pressed 10 kΩ or higher
5 - 6 ODO TRIP switch pressed Below 1 Ω
4 - 6 RHEOSTAT switch not pressed 10 kΩ or higher
4 - 6 RHEOSTAT switch pressed Below 1 Ω
10 - 6 H SWITCH switch not pressed 10 kΩ or higher
10 - 6 H SWITCH switch pressed Below 1 Ω
2 - 6 RSET SWITCH switch not pressed 10 kΩ or higher
2 - 6 RSET SWITCH switch pressed Below 1 Ω
9 - 6 Always Below 1 Ω
8 - 6 M switch not pressed 10 kΩ or higher
8 - 6 M SWITCH switch pressed Below 1 Ω
7 - 6 Off 10 kΩ or higher
7 - 6 On Below 23.4 Ω

Text in Illustration
*a Component without harness connected
(Trip Switch)


If the result is not as specified, replace the trip switch.


b.

Illumination Inspection

i.

Apply battery voltage to the trip switch and check that the switch illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 9
Battery negative (-) → Terminal 6
Illuminates


If the result is not as specified, replace the trip switch.



Hide 84330 2.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY (for RHD)

a.
E136319E49
0.219,0.104 0.563,0.448 0.344,0.344 10 false *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 - 1 Hazard warning signal switch off 10 kΩ or higher
4 - 1 Hazard warning signal switch on Below 1 Ω

Text in Illustration
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


If the result is not as specified, replace the hazard warning signal switch assembly.


b.

Illumination Inspection

i.

Apply battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 3
Battery negative (-) → Terminal 2
Illuminates


If the result is not as specified, replace the hazard warning signal switch assembly.