84155
1.INSPECT AFS OFF SWITCH (for LHD)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 4 | On (Pushed) | Below 1 Ω |
| 1 - 4 | Off (Not pushed) | 10 kΩ or higher |
| *a | Component without harness connected
(AFS OFF Switch) |
If the result is not as specified, replace the AFS OFF switch.
Apply battery voltage to the AFS OFF switch and check that the switch illuminates.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 3
Battery negative (-) → Terminal 2 |
Illuminates |
If the result is not as specified, replace the AFS OFF switch.
84970
2.INSPECT COMBINATION SWITCH ASSEMBLY (AFS OFF SWITCH) (for RHD)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 - 9 | Combination switch assembly (AFS OFF switch) not pressed | 10 kΩ or higher |
| 2 - 9 | Combination switch assembly (AFS OFF switch) pressed | Below 1 Ω |
| *a | Component without harness connected
(Combination Switch Assembly (AFS OFF Switch)) |
If the result is not as specified, replace the combination switch assembly (AFS OFF switch).
Apply battery voltage to the combination switch assembly (AFS OFF switch) and check that the switch illuminates.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 5
Battery negative (-) → Terminal 7 |
Illuminates |
If the result is not as specified, replace the combination switch assembly (AFS OFF switch).