Home › Vehicle Interior › LIGHTING › AUTOMATIC LIGHT CONTROL SENSOR
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291955 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING  AUTOMATIC LIGHT CONTROL SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89120 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

E050991E07
1.396,1.51 0.74,1.51 false 1.979,1.563 2.656,1.563 false 1.979,1.26 2.667,1.26 false 0.146,1.417 0.76,1.573 0.615,0.156 10 false CLTB (+) 2.698,1.188 3.271,1.344 0.573,0.156 10 false CLTE (-) 2.708,1.51 3.323,1.667 0.615,0.156 10 false CLTS (+)

a.

Measure the resistance of the sensor.

Standard resistance:
Tester Connection Switch Condition Specified Condition
3 CLTE (Battery positive (+)) - Body ground Always Below 1 Ω


If the result is not as specified, replace the sensor.


b.

Measure the voltage of the sensor.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
6 CLTB (Battery positive (+)) - 3 CLTE (Battery negative (-)) IG ON 10 to 14V
6 CLTB (Battery positive (+)) - 3 CLTE (Battery negative (-)) IG OFF 0 V
5 CLTS (Battery positive (+)) - 3 CLTE (Battery negative (-)) IG ON (Head light dimmer switch AUTO) Pulse occurs


If the result is not as specified, replace the sensor.