Use the same procedure for the RH and LH side.
The procedure listed below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.REMOVE FRONT FENDER LOWER LINER
Fully turn the steering wheel to the right.
Remove the 2 clips and 2 screws.
Remove the front fender lower liner.
81139
3.REMOVE HEADLIGHT SOCKET COVER
Turn the headlight socket cover in the direction indicated by the arrow shown in the illustration, and remove it.
81110L
4.REMOVE DISCHARGE HEADLIGHT BULB
Turn the light control ECU socket in the direction indicated by the arrow shown in the illustration, and separate it.
Release the set spring and remove the discharge headlight bulb in the direction indicated by the arrow shown in the illustration.
Do not touch the bulb glass.