Home › Vehicle Interior › LIGHTING › STOP LIGHT SWITCH › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291961 STOP LIGHT SWITCH G

LIGHTING  STOP LIGHT SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

a.
U189983E02
1.417,1.375 1.146,1.76 false 1.719,1.396 1.75,1.792 false 2.021,1.396 2.229,1.781 false 1.583,0.448 2.156,0.74 0.573,0.292 10 false A37 1.042,1.802 1.313,1.99 0.271,0.188 10 false B 1.563,1.802 2.104,1.99 0.542,0.188 10 false GND 2.219,1.802 2.49,1.99 0.271,0.188 10 false B 0.219,0.125 0.792,0.417 0.573,0.292 10 false *a

Disconnect the A37 stop light switch assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A37-1 (B) - A37-3 (GND) Always 11 to 14 V
A37-5 (B) - A37-3 (GND) Engine switch on (IG) 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
A37-3 (GND) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Stop Light Switch Assembly)

If the result is not as specified, repair or replace the wire harness or connector.


c.
U189947E01
0.183,0.128 0.379,0.286 0.196,0.158 10 *a 1.571,0.221 1.848,0.398 0.277,0.176 10 A37 0.792,1.494 0.932,1.671 0.140,0.176 10 L 1.166,1.745 1.527,1.922 0.361,0.176 10 GND 2.43,1.469 2.577,1.645 0.147,0.176 10 L 1.526,1.091 0.944,1.535 false 1.692,1.096 1.364,1.745 false 1.932,1.069 2.401,1.482 false

Reconnect the A37 connector to the stop light switch assembly.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A37-2 (L) - A37-3 (GND) Brake pedal not depressed Below 1 V
A37-2 (L) - A37-3 (GND) Brake pedal depressed 11 to 14 V
A37-4 (L) - A37-3 (GND) Engine switch on (IG), brake pedal not depressed 11 to 14 V
A37-4 (L) - A37-3 (GND) Engine switch on (IG), brake pedal depressed Below 1 V


Text in Illustration
*a Component with harness connected
(Stop Light Switch Assembly)

If the result is not as specified, replace the stop light switch assembly.