Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE REAR COMBINATION LIGHT ASSEMBLY
Remove the 2 screws.
| *1 | Rear Combination Light Guide |
Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the rear combination light guide and separate the rear combination light assembly.
Disconnect the connector to remove the rear combination light assembly.
67939D
2.REMOVE BACK DOOR CENTER GARNISH
67848
3.REMOVE BACK DOOR SERVICE HOLE COVER LH (w/ Power Back Door)
62581H
4.REMOVE REAR WINDOW SIDE GARNISH RH
62582H
5.REMOVE REAR WINDOW SIDE GARNISH LH
67750
6.REMOVE BACK DOOR TRIM BOARD ASSEMBLY
84280D
7.REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)
8.REMOVE REAR LIGHT ASSEMBLY
Disconnect the connector.
Remove the 3 nuts.
Disengage the pin to remove the rear light assembly.