Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
81562
1.REMOVE REAR COMBINATION LIGHT LENS GASKET
Remove the rear combination light lens gasket.
Be sure to remove all traces of the old rear combination light lens gasket from the vehicle body.
Do not reuse the removed rear combination light lens gasket. Be sure to install a new rear combination light lens gasket to prevent water ingress.
81550L
2.REMOVE REAR TURN SIGNAL LIGHT BULB
Turn the rear turn signal light socket with the rear turn signal light bulb as shown in the illustration to remove them as a unit.
Remove the rear turn signal light bulb from the rear turn signal light socket.
81550M
3.REMOVE REAR TURN SIGNAL LIGHT SOCKET
Disengage the clamp.
Disconnect the connector to remove the rear turn signal light socket.
81561
4.REMOVE REAR COMBINATION LIGHT LENS
81584
5.REMOVE REAR LIGHT PACKING
Remove the rear light packing.
Be sure to remove all traces of the old rear light packing from the vehicle body.
Do not reuse the removed rear light packing. Be sure to install a new rear light packing to prevent water ingress.
81594A
6.REMOVE REAR LIGHT GASKET
Remove the rear light gasket.
Be sure to remove all traces of the old rear light gasket from the vehicle body.
Do not reuse the removed rear light gasket. Be sure to install a new rear light gasket to prevent water ingress.
81550N
7.REMOVE BACK-UP LIGHT BULB
Turn the rear light socket and wire with the back-up light bulb as shown in the illustration to remove them as a unit.
Remove the back-up light bulb from the rear light socket and wire.
81585
8.REMOVE REAR LIGHT SOCKET AND WIRE
Disengage the 5 clamps.
Disconnect the connector to remove the rear light socket and wire.
81591B
9.REMOVE REAR LIGHT LENS AND BODY