Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM(for LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291968 LIGHTING SYSTEM(for LED Headlight) J

LIGHTING  LIGHTING SYSTEM(for LED Headlight)  Headlight Dimmer Switch Circuit  


DESCRIPTION

The main body ECU receives the following switch information:

·

Light control switch in off, tail, head or AUTO position

·

Dimmer switch in high, low or high flash (pass) position


WIRING DIAGRAM

E349357E03
5.271,5.938 6.313,6.344 1.042,0.406 10 false Main Body ECU 4.865,3.979 5.25,4.219 0.385,0.24 10 false G57 4.896,3.823 5.281,4.063 0.385,0.24 10 false 13 5.188,3.896 5.573,4.135 0.385,0.24 10 false HF 5.188,3.458 5.573,3.698 0.385,0.24 10 false HU 4.354,3.542 4.74,3.781 0.385,0.24 10 false 4D 4.396,3.365 4.781,3.604 0.385,0.24 10 false 10 4.875,1.938 5.26,2.177 0.385,0.24 10 false G57 4.885,1.271 5.271,1.51 0.385,0.24 10 false G57 4.875,1.604 5.26,1.844 0.385,0.24 10 false G58 4.917,1.083 5.302,1.323 0.385,0.24 10 false 23 4.917,1.448 5.302,1.688 0.385,0.24 10 false 17 4.927,1.76 5.313,2 0.385,0.24 10 false 21 5.885,0.594 6.271,0.833 0.385,0.24 10 false +B 6.177,0.594 6.563,0.833 0.385,0.24 10 false +B 5.198,1.167 5.583,1.406 0.385,0.24 10 false TAIL 5.188,1.49 5.573,1.729 0.385,0.24 10 false HEAD 5.198,1.833 5.583,2.073 0.385,0.24 10 false A 3.979,1.177 4.365,1.417 0.385,0.24 10 false 13 3.99,1.49 4.375,1.729 0.385,0.24 10 false 11 3.979,1.833 4.365,2.073 0.385,0.24 10 false 12 3.792,1.177 4.177,1.417 0.385,0.24 10 false T 3.792,1.49 4.177,1.729 0.385,0.24 10 false H 3.792,1.833 4.177,2.073 0.385,0.24 10 false A 3.719,3.458 4.104,3.698 0.385,0.24 10 false HU 3.74,3.896 4.125,4.135 0.385,0.24 10 false HF 3.969,3.458 4.354,3.698 0.385,0.24 10 false 20 3.969,3.885 4.354,4.125 0.385,0.24 10 false 14 0.479,5.625 0.865,5.865 0.385,0.24 10 false EL 0.469,5.823 0.854,6.063 0.385,0.24 10 false 19 3.427,2.26 3.813,2.5 0.385,0.24 10 false A 3.031,2.26 3.417,2.5 0.385,0.24 10 false H 2.635,2.26 3.021,2.5 0.385,0.24 10 false T 2.198,2.26 2.583,2.5 0.385,0.24 10 false EL 2.229,4.302 2.615,4.542 0.385,0.24 10 false EL 3.01,4.302 3.396,4.542 0.385,0.24 10 false HU 3.427,4.302 3.813,4.542 0.385,0.24 10 false HF 2.615,4.302 3,4.542 0.385,0.24 10 false HL 1.729,2.458 2.115,2.698 0.385,0.24 10 false OFF 1.75,2.656 2.135,2.896 0.385,0.24 10 false Tail 1.719,2.844 2.104,3.083 0.385,0.24 10 false Head 1.688,3.042 2.073,3.281 0.385,0.24 10 false AUTO 1.76,4.49 2.146,4.729 0.385,0.24 10 false Low 1.76,4.688 2.146,4.927 0.385,0.24 10 false High 1.729,4.885 2.115,5.125 0.385,0.24 10 false Flash 0.781,5.99 3.104,6.26 2.323,0.271 10 false Headlight Dimmer Switch Assembly 0.781,5.844 1.167,6.083 0.385,0.24 10 false G8 0.688,4.51 2.708,4.813 2.021,0.302 10 false Dimmer Switch 0.604,2.479 1.604,2.969 1,0.49 10 false Light Control Switch


PROCEDURE

1.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

Read the Data List according to the display on the GTS.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Dimmer SW Dimmer switch high position signal/ON or OFF ON: Dimmer switch in high or high flash position
OFF: Dimmer switch in low position
-
Passing Light SW Dimmer switch high flash position (pass) signal/ON or OFF ON: Dimmer switch in high flash position
OFF: Dimmer switch not in high flash position
-
Auto Light SW Light control switch AUTO position signal/ON or OFF ON: Light control switch in AUTO position
OFF: Light control switch not in AUTO position
-
Head Light SW (Head) Light control switch head position signal/ON or OFF ON: Light control switch in head position
OFF: Light control switch not in head position
-
Head Light SW (Tail) Light control switch tail position signal/ON or OFF ON: Light control switch in tail or head position
OFF: Light control switch in neither tail nor head position
-

OK:

Normal conditions listed above are displayed.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
2.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
HINT:

Inspect the items that did not change as a result of monitoring the Data List.


a.

Remove the headlight dimmer switch assembly (See page Vehicle Interior>LIGHTING>HEADLIGHT DIMMER SWITCH>REMOVAL).


b.

Inspect the headlight dimmer switch assembly (See page Vehicle Interior>LIGHTING>HEADLIGHT DIMMER SWITCH>INSPECTION).



OK

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH ASSEMBLY - MAIN BODY ECU)

NG

REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH ASSEMBLY - MAIN BODY ECU)
a.

Disconnect the G57 and G58 main body ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G8-13 (T) - G57-23 (TAIL) Always Below 1 Ω
G8-11 (H) - G58-17 (HEAD) Always Below 1 Ω
G8-12 (A) - G57-21 (A) Always Below 1 Ω
G8-20 (HU) - 4D-10 Always Below 1 Ω
G8-14 (HF) - G57-13 (HF) Always Below 1 Ω
G8-13 (T) or G57-23 (TAIL) - Body ground Always 10 kΩ or higher
G8-11 (H) or G58-17 (HEAD) - Body ground Always 10 kΩ or higher
G8-12 (A) or G57-21 (A) - Body ground Always 10 kΩ or higher
G8-20 (HU) or 4D-10 - Body ground Always 10 kΩ or higher
G8-14 (HF) or G57-13 (HF) - Body ground Always 10 kΩ or higher
G8-19 (EL) - Body ground Always Below 1 Ω




OK

REPLACE MAIN BODY ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR