The main body ECU controls the operation of the TAIL relay.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Taillight Relay | Taillight relay | ON/OFF | - |
Taillight relay operates. (Taillights illuminate.)
OK
NG
Disconnect the 4O main body ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4O-1 - Body ground | Always | 11 to 14 V |
OK
NG