Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM(for LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291968 LIGHTING SYSTEM(for LED Headlight) D

LIGHTING  LIGHTING SYSTEM(for LED Headlight)  INITIALIZATION  


NOTICE:
·

Initialize the headlight leveling ECU assembly when the headlight leveling ECU assembly is replaced.

·

Initialize the headlight leveling ECU assembly (set the zero point of the height control sensor in the headlight leveling ECU assembly) after the vehicle height changes due to replacement of suspension components or after performing operations such as removal and reinstallation or replacement of the rear height control sensor sub-assembly LH.

·

Adjust the headlight aim after initializing the headlight leveling ECU assembly. (See page Vehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(for LED Headlight)>ADJUSTMENT).

·

When a malfunction is detected in the automatic headlight beam level control system, height control sensor signal initialization is impossible. Perform troubleshooting before initialization.



1.PREPARE VEHICLE FOR INITIALIZATION


a.

Unload the vehicle, ensuring that the spare tire, tools and jack are in their original positions.


b.

Check that there are no occupants in the vehicle.


c.

Turn off the headlights.


d.

Stop the vehicle on a level surface and keep the vehicle height unchanged.

Result:
Proceed to
NEXT




2.CHECK MULTI-INFORMATION DISPLAY


a.

Turn the engine switch on (IG), and check the condition of the "Headlight System Malfunction Visit Your Dealer" warning message on the multi-information display.

OK:
Condition Specified Condition
The headlight leveling ECU assembly has been replaced with a new one. "Headlight System Malfunction Visit Your Dealer" blinks 6 times at 2 Hz.
Replacement of the rear height control sensor sub-assembly LH, removal and reinstallation of the rear height control sensor sub-assembly LH, replacement of the suspension, etc. have been performed. "Headlight System Malfunction Visit Your Dealer" is not displayed.


HINT:

If the "Headlight System Malfunction Visit Your Dealer" warning message on the multi-information display does not come on when turning the engine switch on (IG), inspect and repair it according to Problem Symptoms Table (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>PROBLEM SYMPTOMS TABLE).


Result:
Result Proceed to
OK GO TO STEP 3
NG GO TO PROBLEM SYMPTOMS TABLE (See page (Click here))




3.INITIALIZATION


a.
E106867E66
1.425,0.119 1.685,0.294 0.260,0.175 10 CG 0.113,0.033 0.314,0.208 0.201,0.175 10 *a 2.896,0.62 3.162,0.790 0.266,0.170 10 LVL 2.269,0.715 2.83,0.715 false 1.558,0.726 1.558,0.309 false

Connect terminals 4 (CG) and 8 (LVL) of the DLC3 using SST.


b.
SST
09843-18040  


c.
E348858E02
0.602,1.563 0.945,1.721 0.343,0.158 10 A 1.122,1.563 1.465,1.721 0.343,0.158 10 B 1.612,1.563 1.956,1.721 0.343,0.158 10 C 2.11,1.563 2.454,1.721 0.343,0.158 10 D 2.63,1.563 2.974,1.721 0.343,0.158 10 E 0.16,0.127 0.693,0.399 0.533,0.272 10 *b

Turn the low beam headlights on and off using the light control switch within 20 seconds after connecting the terminals.

HINT:

The number of times the low beam headlights need to be turned on and off is determined by the present fuel level as shown below.

Fuel Level Number of Times to Turn Low Beam Headlights On and Off
Fuel level is within A range. 1
Fuel level is within B range. 2
Fuel level is within C range. 3
Fuel level is within D range. 4
Fuel level is within E range. 5


NOTICE:
·

Turn the low beam headlights on and off at less than 3-second intervals.

·

Be sure to operate the light control switch from outside the vehicle.




d.

Check the condition of the "Headlight System Malfunction Visit Your Dealer" warning message on the multi-information display.

OK:
Condition Specified Condition
The headlight leveling ECU assembly has been replaced with a new one. Blinks 6 times at 2 Hz → Blinks N* times at 2 Hz.
Replacement of the rear height control sensor sub-assembly LH, removal and reinstallation of the rear height control sensor sub-assembly LH, replacement of the suspension, etc. have been performed. Off → Blinks N* times at 2 Hz.


Text in Illustration
*a DLC3
*b Fuel Receiver Gauge

HINT:
·

*: The number of times that "Headlight System Malfunction Visit Your Dealer" blinks is determined by the number of times the low beam headlights are turned on and off.

·

If initialization does not finish normally, turn the engine switch off and restart procedure from step (a).



Result:
Result Proceed to
NG GO TO PROBLEM SYMPTOMS TABLE (See page (Click here))
OK TURN ENGINE SWITCH OFF (END)