Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM(for LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291968 LIGHTING SYSTEM(for LED Headlight) U

LIGHTING  LIGHTING SYSTEM(for LED Headlight)  FAIL-SAFE CHART  


LED HEADLIGHT SYSTEM


The headlight light control ECU sub-assembly operates in fail-safe mode if an abnormal condition such as those listed below is detected.

Item Abnormal Detection Condition Return Condition Multi-information Display
Abnormal input voltage
(High input voltage)
Abnormal power source voltage (more than 17 V) is detected. Normal power source voltage (10 to 16 V) is detected. "Headlight System Malfunction Visit Your Dealer" is displayed
Abnormal input voltage
(Low input voltage)*
Power source voltage is low (8.5 to 10 V) and LED output current is limited. (The headlights will remain illuminated.) Normal power source voltage (10 to 16 V) is detected. "Headlight System Malfunction Visit Your Dealer" is displayed
Power source voltage is low (below 6 V) and headlight operation stops. Power source voltage of 8.5 V or more is detected
Abnormal output
·

Open in output side circuit

·

Short between output terminal and body ground

·

Short between output terminals (Hi and Lo)


Light control switch is turned from off to head position. "Headlight System Malfunction Visit Your Dealer" is displayed

*: When the headlights are on and the input voltage is between 6 and 10 V, the headlights dim



AUTOMATIC LIGHT CONTROL SYSTEM


If the main body ECU detects a malfunction in the automatic light control sensor, the main body ECU performs fail-safe control to prohibit the automatic light control. If the low beam headlights and taillights are on, the lights will remain on until the light control switch is turned off.


AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM


The headlight leveling ECU assembly operates in fail-safe mode if an abnormal condition such as those listed below has been detected, and keeps the last low beam status.

Item Abnormal Detection Condition Return Condition Multi-information Display
Height control sensor power source voltage Abnormal rear height control sensor power source voltage (4.6 V or less, or 6.25 V or more) is detected. Abnormal voltage is not detected for 5 seconds consecutively "Headlight System Malfunction Visit Your Dealer" is displayed
Height control sensor signal voltage Abnormal rear height control sensor signal voltage (0.25 V or less, or 4.75 V or more) is detected.
High power source voltage Abnormally high IG supply voltage (18.5 V or more) is detected. Voltage of 17.5 V or less is detected "Headlight System Malfunction Visit Your Dealer" is not displayed
Low power source voltage Abnormally low IG supply voltage (9.0 V or less) is detected. Voltage of 9.3 V or more is detected for 0.1 seconds "Headlight System Malfunction Visit Your Dealer" is not displayed
Reset while running Reset by a temporary loss of power etc. while driving. Vehicle is stopped "Headlight System Malfunction Visit Your Dealer" is not displayed