Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM(for LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291968 LIGHTING SYSTEM(for LED Headlight) A

LIGHTING  LIGHTING SYSTEM(for LED Headlight)  CUSTOMIZE PARAMETERS  


PROCEDURE

Hide 1.CUSTOMIZE LIGHTING SYSTEM

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



HINT:

The following items can be customized.


a.

Customizing with the GTS

i.

Connect the GTS to the DLC3.


ii.

Turn the engine switch to on (IG).


iii.

Turn the GTS on.


iv.

Enter the following menus: Customize Setting / Illuminated Entry or Light Control.


v.

Select the setting by referring to the table below.

Illuminated Entry
Display Default Contents Setting Relevant ECU
Lighting Time 15 s Changes illumination duration after door closure.
(It will quickly fade out in case of turning engine switch on (IG).
7.5 s / 15 s / 30 s Main body ECU
I/L when ACC OFF ON Illuminates light when engine switch turned on (ACC).
(Room light illuminated when map light switch in DOOR position)
ON / OFF
I/L ON W/Door Key Unlock ON Function to light up room light, when unlocking with door key cylinder/wireless transmitter.
(Room light illuminated when map light switch in DOOR position)
ON / OFF
Illumination System ON Illuminated entry function ON / OFF
Light Control ON Function to light up inside handle illumination lights when engine switch is on (IG) and shift position is not P. ON / OFF
Interior Light Control ON Function to light up room light, when the illuminated entry function is operating. ON / OFF

Light Control
Display Default Contents Setting Relevant ECU
Response Time Normal Delay time Normal / Long Main body ECU
Disp Ex ON Sen Normal Changes the ambient brightness level required to dim the lights such as the indicator lights of the combination meter, A/C indicator light and clock. Normal
Dark2
Dark1
Light1
Light2
Disp Ex OFF Sen Normal Changes the ambient brightness level required to cancel the dimming of the lights such as the indicator lights of the combination meter, A/C indicator light and clock. Normal
Dark2
Dark1
Light1
Light2
Sensitivity Normal Sensitivity adjustment Normal
Dark2
Dark1
Light1
Light2
Daylight Function ON ON/OFF of the Daytime light function ON / OFF

HINT:

The sensitivity adjustment may be difficult to confirm. Check by driving the vehicle.




b.

Customizing with the multi-display

i.

Turn the engine switch to on (IG).


ii.

Enter the following menus: SETUP / Vehicle / Vehicle customization / Light settings.


iii.

Select the setting by referring to the table below.

Light settings
Display Default Contents Setting Relevant ECU
Sensitivity Normal Sensitivity adjustment Normal
Dark2
Dark1
Light1
Light2
Main body ECU
Lighting Time 15 s Changes illumination duration after door closure.
(It will quickly fade out in case of turning engine switch on (IG)).
7.5 s / 15 s / 30 s

HINT:

The sensitivity adjustments are difficult to confirm.

Check by driving the customer's vehicle.